Repairing the car after the accident
Repair the car after the accident must be preceded by an accurate determination of cause resulting incident, otherwise the driver will be exposed to the fact that after some time again cause a car accident because of this that drives a defective car. The reason for the resulting failure can be either a technical defect, for which the driver is not responsible and long-term use of motor oils of poor quality. Therefore, when car repair is done, exchange the damaged parts, and selects a good engine oil, the driver should now use. Allowing the car to re-use will be made only after a thorough verification of the state of the already made repairs.
How do you get your car repaired?
Defects or minor failures occur in every car, and this is due to its operation. It would seem that the older the car, the more trouble, however, and the latest models can sometimes give bone its owner. In such a situation, there is nothing else to look for a mechanic who not only repair the vehicle, but the occasion does not demand for the service a lot of money. The cost will depend on how large the scope of work will need to be carried out and whether it is necessary to buy spare parts. Surely every driver wants to give up your car in the best possible hands, so it is worth looking mechanics guided by the opinion of customers who have already benefited from its services and are happy with the result.
An example is lubricating oil
An example is lubricating oil for four-stroke or four-cycle internal combustion engines such as those used in portable electricity generators and "walk behind" lawn mowers. Another example is two-stroke oil for lubrication of two-stroke or two-cycle internal combustion engines found in snow blowers, chain saws, model air planes, gasoline powered gardening equipment like hedge trimmers, leaf blowers and soil cultivators. Often, these motors are not exposed to as wide service temperature ranges as in vehicles, so these oils may be single viscosity oils.
In small two-stroke engines, the oil may be pre-mixed with the gasoline or fuel, often in a rich gasoline:oil ratio of 25:1, 40:1 or 50:1, and burned in use along with the gasoline. Larger two-stroke engines used in boats and motorcycles may have a more economical oil injection system rather than oil pre-mixed into the gasoline. The oil injection system is not used on small engines used in applications like snowblowers and trolling motors as the oil injection system is too expensive for small engines and would take up too much room on the equipment. The oil properties will vary according to the individual needs of these devices. Non-smoking two-stroke oils are composed of esters or polyglycols. Environmental legislation for leisure marine applications, especially in Europe, encouraged the use of ester-based two cycle oil.
Źródło: https://en.wikipedia.org/wiki/Motor_oil